Has this happened to you on Pump fun?

[Deleted member 1603965]

So I had put 0.5 Sol on a token. It went to 1 Sol after getting bonded but the buy sell console was like not getting loaded. I checked my internet speed and it was fine. I lost the amount it seems as when the console loaded, everyone just sold by then. My question is, should I build such positions on pump fun directly? So far bonkbot is what I am using but I then thought of using some screeners and filters so that I can get in as early as possible.

I know some of you will say that it wasn't a good decision to put in this much but the thing is that the token had almost 800+ holders pre bonding itself and its chart looked natural too. Not to mention the meta was fine too. Like a good meme. Just so sad right now. I know it is a small setback but 0.5 Sol in a trade would have helped me a lot in my journey which I am trying to complete (100X of base capital one).

As of writing, the token is recovering but the volumes are down.

 

[theeyeinside]

Why are you using Pump Fun? The only thing being pumped is you.

Take the Memecoin Mastery course ($4K) in the downloads section

Then look for coins like he advises. Just use Dexscreener

And don't forget Rug Check

It is a grind job, buy someone has to do it

Sincerely,

The Eye

 

[Deleted member 1603965]

Why are you using Pump Fun? The only thing being pumped is you.

Take the Memecoin Mastery course ($4K) in the downloads section

Then look for coins like he advises. Just use Dexscreener

And don't forget Rug Check

It is a grind job, buy someone has to do it

Sincerely,

The Eye

I asked about the technical glitch. I know what I am doing. 99.99% tokens on pump are scams but if you have an idea of what you are doing, you can get in early on tokens and make good money.

Also if you believe that blindly following some course will make you money, then IDK what to say even.

 

[Rakzs]

I suggest Trojan bot over Bonk, I had similar issues with Bonk before. Make sure your slippage and gas fees are high enough and spam the sell if it doesn't load (or use one of the backup trojan bots).

 

[Deleted member 1603965]

I suggest Trojan bot over Bonk, I had similar issues with Bonk before. Make sure your slippage and gas fees are high enough and spam the sell if it doesn't load (or use one of the backup trojan bots).

Did you even read my post?

 

[maskedhr]

So I had put 0.5 Sol on a token. It went to 1 Sol after getting bonded but the buy sell console was like not getting loaded. I checked my internet speed and it was fine. I lost the amount it seems as when the console loaded, everyone just sold by then. My question is, should I build such positions on pump fun directly? So far bonkbot is what I am using but I then thought of using some screeners and filters so that I can get in as early as possible.

I know some of you will say that it wasn't a good decision to put in this much but the thing is that the token had almost 800+ holders pre bonding itself and its chart looked natural too. Not to mention the meta was fine too. Like a good meme. Just so sad right now. I know it is a small setback but 0.5 Sol in a trade would have helped me a lot in my journey which I am trying to complete (100X of base capital one).

As of writing, the token is recovering but the volumes are down.

once the bonding curve is completed the token is locked and goes into migration phase, where it is migrated to radium. during this phase you cant trade that token. this maybe the case with you.

 

[Deleted member 1603965]

once the bonding curve is completed the token is locked and goes into migration phase, where it is migrated to radium. during this phase you cant trade that token. this maybe the case with you.

I could see the trading post migration but my buy/ sell console on Pump just didn't load.

 

[maskedhr]

I could see the trading post migration but my buy/ sell console on Pump just didn't load.

nah, i dont hold the coin till it reaches the bonding curve so cant tell what exactly hapens post that, is the issue with just one coin?

 

[Deleted member 1603965]

nah, i dont hold the coin till it reaches the bonding curve so cant tell what exactly hapens post that, is the issue with just one coin?

Obviously it happened only one time with me. And if you don't have any idea about what someone is asking about, why derail/ spam the thread?

 

[Groot Agency]

Memecoin is a gamble, knowledge. So if you dont, you can leave for safe

 

[Deleted member 1603965]

Memecoin is a gamble, knowledge. So if you dont, you can leave for safe

Do you even know what I asked? I was asking about a technical glitch.

 

[davids355]

Let’s keep things friendly guys we are a community of like-minded individuals and should be helping each other out whenever possible.

 

[Rakzs]

Did you even read my post?

Did you read mine? I said I had the same issue with Bonk bot, so what do you think? Why do you think I suggested Trojan?

 

[Deleted member 1603965]

Did you read mine? I said I had the same issue with Bonk bot, so what do you think? Why do you think I suggested Trojan?

I was trading on pump fun console which looks something like this.

 

[Rakzs]

I was trading on pump fun console which looks something like this.

View attachment 419496

I had an issue with bonk where it would lag and delay in a similar way not loading the sell for a few seconds even if I spam sent it. I suggest you go for Trojan or maybe BullX, they're the fastest and you won't have lag especially in memecoins where a second could make a big difference.

 

[Recyclooor]

So I had put 0.5 Sol on a token. It went to 1 Sol after getting bonded but the buy sell console was like not getting loaded. I checked my internet speed and it was fine. I lost the amount it seems as when the console loaded, everyone just sold by then. My question is, should I build such positions on pump fun directly? So far bonkbot is what I am using but I then thought of using some screeners and filters so that I can get in as early as possible.

I know some of you will say that it wasn't a good decision to put in this much but the thing is that the token had almost 800+ holders pre bonding itself and its chart looked natural too. Not to mention the meta was fine too. Like a good meme. Just so sad right now. I know it is a small setback but 0.5 Sol in a trade would have helped me a lot in my journey which I am trying to complete (100X of base capital one).

As of writing, the token is recovering but the volumes are down.

Use bloom bot on telegram. They allow you to snipe migration with sell/buy

 

[Deleted member 1603965]

I had an issue with bonk where it would lag and delay in a similar way not loading the sell for a few seconds even if I spam sent it. I suggest you go for Trojan or maybe BullX, they're the fastest and you won't have lag especially in memecoins where a second could make a big difference.

Pump fun has a wallet too mate. Like you can trade without a bot there directly.

 

[Rakzs]

Pump fun has a wallet too mate. Like you can trade without a bot there directly.

I think it's slower imo, I've ran a few coins on there and that's the only experience I have on site otherwise I use bots, I prefer going for bots in general. Good ways to setup autosells if needed too.

 

[Deleted member 1603965]

I think it's slower imo, I've ran a few coins on there and that's the only experience I have on site otherwise I use bots, I prefer going for bots in general. Good ways to setup autosells if needed too.

OKOK. Understood.

 

[cojocusd]

So I had put 0.5 Sol on a token. It went to 1 Sol after getting bonded but the buy sell console was like not getting loaded. I checked my internet speed and it was fine. I lost the amount it seems as when the console loaded, everyone just sold by then. My question is, should I build such positions on pump fun directly? So far bonkbot is what I am using but I then thought of using some screeners and filters so that I can get in as early as possible.

I know some of you will say that it wasn't a good decision to put in this much but the thing is that the token had almost 800+ holders pre bonding itself and its chart looked natural too. Not to mention the meta was fine too. Like a good meme. Just so sad right now. I know it is a small setback but 0.5 Sol in a trade would have helped me a lot in my journey which I am trying to complete (100X of base capital one).

As of writing, the token is recovering but the volumes are down.

during the migration from pf to ray the pf console is not goona work or it will have pretty high delays same as any other dex, ppl have sold before you cause they use trading bots, so when the liquidity was detected they could sell fast and fuck the chart. always try to take profits before bonding, no matter how good a meme looks
Also consider using higher slippage around 15-20%