1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

imacros help

Discussion in 'Social Networking Sites' started by Crazy Monkey, Jan 9, 2016.

  1. Crazy Monkey

    Crazy Monkey Jr. VIP Jr. VIP

    Joined:
    Aug 4, 2015
    Messages:
    1,961
    Likes Received:
    240
    Gender:
    Male
    Location:
    In Jungle
    short question... what command on imacros i should use, when i want to SET the Timeout till the page is leaded? not in seconds, just until the page is loaded. any solutions?
     
  2. sashablack

    sashablack Elite Member

    Joined:
    Jan 8, 2010
    Messages:
    3,697
    Likes Received:
    2,059
    Gender:
    Male
    i don't think there is such a command, there is a timeout you can set. Or you can set this:

    HTML:
    SET !TIMEOUT_STEP 0
    after url load

    -Sasha
     
  3. HoNeYBiRD

    HoNeYBiRD Jr. VIP Jr. VIP

    Joined:
    May 1, 2009
    Messages:
    6,954
    Likes Received:
    7,984
    Gender:
    Male
    Occupation:
    Geographer, Tourism Manager
    Location:
    Ghosted
    the macro should wait until a page fully loads, so you don't need to set anything normally

    the default timeout is 60 secs, is that too few or too much?

    oftentimes you need to force imacros to wait a bit after a page is loaded, because sometimes it would like to do things too fast and doesn't found the specified element, only if you put wait seconds
    WAIT SECONDS=x
    or
    SET !TIMEOUT_STEP x

    you can set any amount of seconds for the timeout
    SET TIMEOUT_PAGE=x

    if none of that helps, try this or maybe start with this :)
    http://wiki.imacros.net/!WAITPAGECOMPLETE
     
    Last edited: Jan 9, 2016
  4. seodeal

    seodeal Jr. VIP Jr. VIP

    Joined:
    Jun 29, 2013
    Messages:
    352
    Likes Received:
    39
    Try to schedule a timeout in between them to make sense and get best results